User Manual

Doc P/N: 9040962 | Rev 01 | Printed 22 July 2016
20
CONNEX ProSight Installation and Operation Guide
Installing the Units|Wiring the HD Transmitter
Navigation pane
B- Connecting to Flight Controller
Home Page
Safety
Introduction to CONNEX
ProSight
Opening the Package
Installing the Units
Operating the Units
Configuration Using
ProSight Desktop
Application
Configuration Using
ProSight Mobile
Application
Specifications
Appendices
Wiring the Telemetry Cable
Connect the CC3D Telemetry Cable or the Naze Telemetry Cable to
the HD transmitter telemetry port (1) and the other end as to the flight
controller as follows:
• Connect the fourth wire (2) to the flight controller UART Tx port.
• Connect the third wire (3) to the flight controller UART GND
port.
1
2
3
Tips:
The HD transmitter can connect to any flight controller with a
MAVLink output port.
Obtain your own cable to connect a flight controller which is not
Naze nor CC3D. .