User Manual

Doc P/N: 9040962 | Rev 01 | Printed 22 July 2016
28
CONNEX ProSight Installation and Operation Guide
Installing the Units|Wiring the HD Receiver
Navigation pane
B- Connecting to Power
Home Page
Safety
Introduction to CONNEX
ProSight
Opening the Package
Installing the Units
Operating the Units
Configuration Using
ProSight Desktop
Application
Configuration Using
ProSight Mobile
Application
Specifications
Appendices
To connect the HD receiver to a power source:
1. Connect the HD Receiver Power Cable to the HD receiver power
port (1) and the other end to a power source.
2. Verify that the Network LED (2) on the HD receiver blinks for a few
seconds and then stays lit.
Tips:
• The HD receiver can be connected directly to the battery.
• The HD receiver is compatible with 7V to 17V, or 2S to 4S
batteries.
1
2