User Manual

Doc P/N: 9040962 | Rev 01 | Printed 22 July 2016
65
CONNEX ProSight Installation and Operation Guide
Specifications|CONNEX ProSight
Navigation pane
Specifications
Home Page
» Micro USB – Connection to application; Wired pairing
» UART for Telemetry
Safety
Introduction to CONNEX
ProSight
Opening the Package
Installing the Units
Operating the Units
Configuration Using
ProSight Desktop
Application
Configuration Using
ProSight Mobile
Application
Specifications
Appendices
CONNEX ProSight
• Supported LOS range of 1000ft without any range limitation
• Advanced High-Definition spectator viewing mode
• Receiver Unit outputs standard 720p60 over HDMI for reducing
motion blur
• Compatible with all popular HDMI based Goggles/monitor
• Digitally paired transmitter to receiver for crosstalk free flight
HD Transmitter
• Up to 26mS video latency from Camera lens to HD Receiver
HDMI output
• Power consumption – ~4.1Watt
• Power input – 7v-17v; support 2S to 4S batteries
• Antennas – two external MMCX connectors
• Dimensions – 70mm x 36.5mm x 7.2mm
• Weight – 32 gr
• UX: LEDs – status indication only
• Interfaces –
» Power in (4 pins)
» Power out to the camera & recorder
» Proprietary MIPI (14 pin Right-Angle, JST SM20B-SRSS) –
HD Video input
• Environmental:
» Operating – -10° to 50° C
» Operating humidity – 10% - 90%
» Storage – -10° to 75° C
Camera
• Advanced High-Dynamic-Range Support (115dB)
• HD 720P30 / 720i60 resolution
• FPV Optimized for Outdoor and Indoor flights
• Dimensions – 28mm x 20mm x 27mm
• 105 degrees FOV with pre-focused lens (the lens can be
replaced, although this is not recommended)
• Compatible with ProSight HD transmitter Only
• Power up from ProSight HD transmitter
• Weight – 13gr (6g camera + 7g lens)