User Manual

CONNEX ProSight Installation and Operation Guide
Appendices|CONNEX ProSight Frequency Management
Navigation pane
CONNEX ProSight Frequency Management
Home Page
Safety
Introduction to CONNEX
ProSight
Opening the Package
Installing the Units
Operating the Units
Configuration Using
ProSight Desktop
Application
Configuration Using
ProSight Mobile
Application
Specifications
Appendices
Frequency Management Tools
The ProSight frequency management scheme was designed to observe four constraints:
• Regulatory requirements - regional settings and HAM license
• User ease of use
• Coexistence with other analog and digital systems
• Environmental usage: Indoor or Outdoor
Ease of Use
CONNEX ProSight is a digital system, allowing bi-directional communication between the ProSight HD transmitter and the ProSight HD receiver.
The user manages frequency configuration and operating modes by setting them on the HD receiver. Configuration is performed using either:
• OSD menus, controlled by buttons on the side of the receiver.
• Through a dedicated mobile application, using a wireless bluetooth connection (iOS or Android platform).
• The transmitter is fully controlled by the receiver, which sets its operating frequencies and regional settings.
The CONNEX ProSight supports two modes of operation:
• Automatic mode – used for casual operation by a single or limited number of pilots without the need for manual frequency management.
Each system senses the spectrum and determines the optimal frequency to work on.
• Fixed mode – when racing with multiple pilots, each pilot can set their system to use a specific pre-defined frequency. The frequency list
depends on regional settings and is listed at the end of this appendix.
Doc P/N: 9040962 | Rev 01 | Printed 22 July 2016
71