Installation manual

100 20/10/2004 PS10270JENAA01
Performing a total reset
You must perform a "total" reset the first time the equipment is put in service.
Comments:
• To perform a "total" reset, you need the "installer" password.
• As soon as the initialisation tests begin, type "CO" immediately to switch the system to
manual control.
To perform a "total" reset of the M6501L/R IP PBX:
1 Go to menu 5.1.3 (Restart request). The screen RESTART REQUEST appears.
2 On the line RESTART TYPE, select STANDARD (using the space bar on the PC). Press
Enter.
3 On the line CONFIRMATION, select YES. Press Enter.
4 As soon as the screen begins to display the start up tests, type "CO" to change over to
manual control.
5 Several tests are displayed. Then the line RESET PASSWORD appears. Type in the default
password TOTAL. Press Enter.
Note: If no password is requested, repeat the reset operation.
Wait for the device to run the test series, recognise the installed cards and configure itself
automatically.
This will take a few minutes. When the main menu appears on screen, the initial start-up will
have been completed successfully.
A total reset clears all data from existing programming.
A total reset erases any existing programmed data, and the system configures itself
automatically to the installed equipment.
A total reset should only be performed when instructed, for example if installing new
software.
The system performs an additional reset
If the capacity of the line cards installed exceeds 60 terminals, the system automatically
extends the internal directory number length from two to three digits, then restarts in order
to incorporate the change.
During system restarts, you must wait until the main menu is displayed.
No user intervention is required when the system restarts.