Installation manual

112 20/10/2004 PS10270JENAA01
Installing and putting in service the OCT4 card
The purpose of this operation is to replace the standard OCT3B card with the standard OCT4
card. The OCT4 card is managed in release R2.1 (V14.2) and later.
Steps
1 Before changing the cards, save the customer's data configuration.
2 Power off the M6501L/R IP PBX.
3 Remove the cover on the main cabinet.
4 Unplug the connectors leading from the standard OCTB card.
5 Gently remove the OCT3B card from its slot. Disconnect the VOCT3 daughter card from the
OCT3B card, collecting the card's retaining screws and spacers.
6 Be sure to place the OCT3B in an anti-static envelope.
7 Fit the VOCT3 daughter card on the OCT4 card, using the spacers on the OCT3B card.
8 Insert the OCT4 card in the CPU slot in shelf 0. Slide the card along the card guides until it
clicks into place.
9 Reconnect the connectors to the OCT4 card.
10 Perform a visual inspection to check that the various items are all in position.
11 Replace the front cover on the cabinet.
12 Plug in the external battery and mains power cords.
13 Power on the M6501L/R IP PBX in accordance with the procedure described in Part 1.
14 If a battery is fitted, check that all the green, yellow, and red LEDs on the front panel of the
power supply module are lit.
The system initialisation test will begin, following the procedure described in Part 1.
The startup screen then displays the "PBX management" main menu. The card swap is now
complete.
Restore the customer's data by performing the relevant procedure.
Unlock the various functions by performing the relevant procedure.
Power off
Ensure that power to the system is switched off at all times while the cabinet cover
is open.