Installation manual

128 20/10/2004 PS10270JENAA01
• If the software is supplied on diskette, select the directory C:\VU_F1\Chaining diskette
reference and press RETURN to confirm.
• If the software is supplied on CD-ROM, enter the full directory access path on the CD-
ROM: *.nRP (where n = 1, 2, 3, ... according to the number of software productions for
each step) and press RETURN to confirm.
• Indicate the path for the customer configuration file (initial configuration which must be
on the hard disk) and its name.
• Indicate the path for configuration file after the VUs have been run and its name (final
configuration). Press RETURN to confirm.
• Select the software version you wish to install and press RETURN to confirm.
• When the upgrade is complete, press Esc to go back to the menu
PC TOOLS
SELECTION
.
Note:The new customer configuration file is to be restored in the ICS (Menu 5.2).
7 Restore the customer configuration.
The configuration is restored "off line". The system is stopped during this step and an Auto
Reset is performed. Any calls in progress are interrupted.
• Reset the ICS.
• Press ESC to exit the "DOS Tools" program.
Note: The chaining of these phases is to be defined according to the type of upgrade.