Installation manual

PS10270JENAA01 20/10/2004 17
The table below lists the external links available.
Termination type Card Signalling
analogue network trunk LR4 standard: subscriber signalling with pulse or DTMF dialling
ISDN: T0 BRI interface LS1
LD4
LD4N
Numeris (ISDN) VN3 VN4-compatible
ETSI
ISDN T2 interface LT2 Numeris (ISDN) VN3 VN4-compatible
ETSI
PCM digital line LT2 . DID signalling (Socotel state-change MF for setting up network
calls)
. subscriber signalling (pulse or DTMF dialling for setting up
network calls)
. COLISEE pulse signalling for connection to the COLISEE
network
. COLISEE pulse signalling in master or slave mode for
connection to another private installation
. CLOISEE MF SOCOTEL pulse and state-change line signalling
for connection to the COLISEE network
. L0 pulse signalling for connection to another private installation
analogue 2- or 4-wire 50 Hz
or E&M tie lines
LI1 . COLISEE pulse signalling for connection to the COLISEE
network
. COLISEE pulse signalling in master or slave mode for
connection to another private installation
. MF SOCOTEL pulse and state-change line signalling for
connection to the COLISEE network
. L0 pulse signalling for connection to another private installation
. WINK START signalling for connection to another private
installation
. RITTER signalling for connection to another private installation
tie lines with voice frequency
line signalling
. 2-wire L0 signalling for connection to another private installation
. 4-wire L1 signalling for connection to another private installation
packet-switching network CS1
or
CS1+
CP1
. X25 signalling (2400, 4800, 19200 b/s, 48 and 64 kb/s)
private network LT2 . QSIG ISDN signalling for connection to another private network
LAN PT2 . MOVACS signalling for using voice over IP gateways