Installation manual

30 20/10/2004 PS10270JENAA01
"B" command: begin
This key moves the cursor to the first field in the first screen of the menu. It is only available in
terminal menus.
The cursor is only moved if the value confirmed in the field in which the cursor is positioned is
correct.
Note: If the cursor is already in the first field, an error message is displayed.
"M" command: more
This key is used to move the cursor to the next screen in the menu. It is only available in terminal
menus.
The cursor is only moved if the value confirmed in the field in which the cursor is positioned is
correct.
If the cursor is already in the last screen, it cannot be moved and an error message is displayed.
"E" command: end
This key moves the cursor to the last field in the menu. It is only available in terminal menus
(except display menus).
The cursor is only moved if the value confirmed in the field in which the cursor is positioned is
correct.
If the cursor is already in the last screen, an error message is displayed.
A change of screen cannot occur if the cursor is in the last screen of the menu.
"O" command: origin (home)
This command is available in all menus, and returns the cursor directly to the first menu.
It requires confirmation. The second session is not re-initialised.
"S" command: mark session; "J": jump
These commands are displayed at the bottom of the screen.
• The "S" command is available in all menus and is used to mark a particular point or session in
a menu. Up to four locations can be marked in this way, numbered 0 to 3.
• The "J" command returns the cursor to the location previously marked by the "S" command.
You must indicate the marker number required (0 to 3).
By default, all the markers are initialised on the main menu at the top of the tree structure. In
certain cases, the previous session is only partially restored, in which case a message specifies
the problem.
Note: The keystroke command box displays the various markers already recorded. Each
marker is displayed on one line.