Installation manual

42 20/10/2004 PS10270JENAA01
Hardware installation procedure
The table below summarises the work involved in installing the du M6501L/R IP PBX hardware.
The steps in the installation procedure are described below.
Installing the hardware
1 Setting the cabinet in place
Unpacking the cabinet Remove the M6501L/R IP PBX from its packaging.
Installing the cabinet on its support Use the wall mounting bracket to mount the cabinet.
Fastening the cabinet to its support
Remove the power supply module and tighten the screw fully,
locking it against the bracket.
Connecting the cabinets
Connect the two cabinets together using the cable supplied with
the expansion cabinet.
2 Installation of cards
Installing the basic cards
Install the optional PROMs then install the daughter cards on
the
OCT4 card
Installing the ISDN cards Install the ISDN S/T PRI cards then the S/T BRI cards
Installing the tie line cards Install the cards used for private trunk line connections
Installing the PSTN cards Install the cards used for analogue trunk line connections
Installing the LAN cards Install the PT2 card for LAN connections
Installing the application cards
Install the application cards: integrated router, V24 interfaces,
etc.
Installing the equipment cards
Install the cards used for equipment line connections: analogue
and digital terminals
3 Wiring to the LAN network Wire the PT2 card to a 10/100 Mbits Ethernet LAN outlet
4 Wiring the distribution frame
Wiring the ISDN interface Wire the ISDN S/T access points
Wiring analogue trunk lines Wire the analogue trunk lines (PSTN)
Wiring the TLs Wire the private trunk lines (tie lines)
Connecting digital sets Connect the digital telephone sets
Connecting analogue terminals Connect the basic sets
Connecting EDP terminals
Connect the synchronous and asynchronous EDP terminals
(RS232C)
Connecting miscellaneous
equipment
Connect the miscellaneous equipment: general bell,
programming console, etc.
- Folio 1 de 2 -