Installation manual

44 20/10/2004 PS10270JENAA01
Setting the cabinet in place
This section describes how to set the cabinet in place on its wall mount. This procedure applies
to M6501R IP PBX and M6501L IP PBX cabinets, because they are identical.
At each stage of the installation, make sure the equipment has not been damaged in any way. If
it has, return it to the supplier.
To put a cabinet in place:
• unpack the cabinet
• install the cabinet on its support
• fasten the cabinet to its support
Unpacking the cabinet(s)
To remove the M6501L/R IP PBX cabinet from its packaging:
1 Place the box on the ground. The ground must be clean and dry. Open the box.
2 Remove the documentation from the box.
3 Tip the box onto one side.
4 Place the opening facing the floor.
5 Raise the packaging carton. Save the fully-recyclable box (standard 2809) for any
subsequent shipment of the equipment.
6 Remove the cabinet's side padding, replacing it in the box, then place the unit on the table.
CAUTION
Make sure you have enough room to unpack all the equipment and store it safely during the
installation procedure.