Installation manual

52 20/10/2004 PS10270JENAA01
Basic cards
ISDN cards
LAN access network card
Card Overview
OCT4 Main card.
This card can be fitted with two daughter cards: TMOCT4 and VOCT3
One card per M6501L/R IP PBX system.
ROCT3B Bus interface card for the expansion cabinet.
This card functions as controller/receiver of various signals, adjusts any cable lag
and controls the PCM bus.
This card has 16 digital lines.
It is only fitted in the M6501L IP PBX expansion cabinet.
One card per M6501L IP PBX system.
TMOCT4 Available in two versions: with or without memory extension. This card has an
additional signal processor identical to that of the OCT4 I card. It must be installed
on the OCT4 card.
VOCT3 Voice prompt and music-on-hold.
This card can be fitted with one or two PROMs: pre-recorded messages and
music-on-hold. This SRAM memory can be used to memorise a new 64-second
greeting message.
It must be installed on the OCT4 card.
Card Overview
LS1 ISDN BRI (2B+D)
This card can be used as an ISDN basic rate interface (T0) or as an ISDN line
interface (S0). It contains either two T0 and two S0, or one T0 and one S0.
LD4 Four ISDN BRI (2B+D) interfaces.
This card can be used as an ISDN basic rate interface (T0) or as an ISDN line
interface (S0) for connecting DECT base stations.
LD4N Four ISDN BRI (2B+D) interfaces.
This card can be used as an ISDN basic rate interface (T0) or as an ISDN line
interface (S0) for connecting DECT base stations.
LT2 ISDN PRI (30B+D)
This card can be used as a PRI trunk access or as a digital PCM trunk.
The ISDN PRI consists of thirty 64 Kbps channels and one 128 Kbps D channel.
The LT2 card can be used for TL/QSIG links.
Card Overview
PT2 CLX interface card for an IEEE 802.3 compliant 10/100 Mbits Ethernet LAN; the
card provides a TCP/IP-X25 gateway and IP tunneling functions. It can be fitted
with a VOIP4 or VOIP4 Edaughter card to manage 8, 16, or 32 voice over IP
circuits.