Installation manual

PS10270JENAA01 20/10/2004 63
Installing the application cards
Installing the application cards
• The switches on the CA1 card are used to set either V10 or V28 mode; the switches that
need to be configured are SW1, SW2, SW3, and SW4.
• You do not need to set any switches on the CP1 card.
• The switches on the CS1 card are used to set either V10 or V28 mode; the switches that
need to be configured are SW1 and SW2.
Application cards are installed in the main cabinet in shelf 0 or shelf 1 only in the slots shown in
the diagrams below:
Card
Main cabinet - Shelf 0
0 1 2 3 4 5
CA1, CHP1,
CP1 and
CS1
YES YES YES YES YES YES
Card
Main cabinet - Shelf 1
0 1 2 3 4 5 6 7
CA1, CHP1,
CP1 and
CS1
YES YES YES YES YES NO NO NO