Installation manual

PS10270JENAA01 20/10/2004 89
Connecting miscellaneous equipment
Connecting the programming console
The programming console is used to interface with the M6501L/R IP PBX for programming,
displaying, and printing site configuration data (when a printer is connected to the programming
console).
It can be a VT100 console or a PC (with VT100 emulation).
The programming console can be connected to the system either directly or remotely. Direct
connections, which must be no longer than 15 m (50ft), run via the distribution frame and end at
the COM port connector assigned to the console on the OCT4 card; remote connections use an
internal modem on the OCT4 card or an external modem.
Note: You are advised to use a PC, because the configuration can only be backed up on a PC.
Serial port (25-pin) on the console
ISO 2110 female connector
(view of solder side)
Carte OCTJ103J
J10
4.
3. GND
2. TXD
1. RXD
Serial port (9-pin) on a PC
ISO 2110 female connect
or
(view of solder side)
J10
OCT3B card
Straps required on connector with
9
pins:
7 and 8; 1 and 4 and 6.
Straps required on connector with
25
pins: