Installation manual

PS10270JENAA01 20/10/2004 97
System setup
When you have installed the hardware, you can turn on the system. This triggers initial start-up,
at which point the system software is loaded, the start-up tests are run, the application program
is loaded and the default configuration is initialised. At the end of this phase, the splash screen
appears on the programming console. The first time the hardware is installed, you must reset the
system before you start programming.
After a total reset, a resident program automatically configures the system using the default
parameters. In the process, the installed cards are activated and recognised.
To set up a new system:
• configure the programming console
• power on the PBX
• perform a total reset
• check the pre-configuration.
Note: Before resetting the system, power up and configure the programming console.
Programming console configuration
To configure the console to link with the system, you need an asynchronous communication
package to emulate the VT 100 console. Many software packages are available. The instructions
given here are for the Windows 95 application Hyperterminal.
1 Go to Accessories > HyperTerminal.
The HyperTerminal icon appears.
2 Open the HyperTerminal application.
3 Enter a name for the connection, and select an icon. Click OK.
4 On the line Connection, select COM 1 or COM 2, depending on the communication port
used. Set the transmission parameters as follows:
5 Click on OK.
Transmission speed 9600
Data bits 8
Parity None
Stop bits 1
Flow control Xon/Xoff