User`s manual

ADVANCED AUTO-SENSING SETTINGS
(The following is only supported by autosensing models)
1. The default of Deactivation Time is 3 Sec.
2. Deactivation Time is the time interval between the last scan and
the automatic deactivation of LED or Laser light in Auto-Sensing
Mode.
3. You can set the Deactivation Time value by the following three
steps:
Step 1: scan Deactivation Time
Step 2: scan two digits(Limit Range: 01 ~ 30sec.) from the Full ASCII
numeric table.
Step 3: scan Deactivation Time
DEACTIVATION TIME
(CCD & LASER SCANNERS)
SAME CODE INTERVAL
(LASER SCANNER ONLY)
1. The default of Same Code Interval is 30 Sec.
2. Same Code Interval is the time interval between two consecutive
scans on the SAME bar code in Auto-Sensing Mode.
3. You can set the value of Same Code Interval by the following three
steps:
Step 1: scan Same Code Interval
Step 2: scan two digits(Limit Range: 03 ~ 60sec.)from the Full ASCII
numeric table.
Step 3: scan Same Code Interval
. F030$
DEACTIVATION TIME
SAME CODE INTERVAL
. F031$
GROUP-16
NOTES:
NOTES:
Idle Mode On
.B026$
.B027$
IDLE MODE
Pre-Idle Time
.B028$
*.B028$*
1. Idle Mode is only supported by certain models.
2. When Idle Mode is on, the scanner will enter idle state to save
power after a period of inactivity, or Pre-Idle Time(the default
is 1 min).
3. You can set the value of Pre-Idle Time by the following four steps:
Step 1: scan Idle Mode On
Step 2: scan Pre-Idle Time
Step 3: scan one digits(Limit Range: 1~9 Min.)from the Full ASCII
numeric table.
Step 4: scan Pre-Idle Time
*.B026$*
*.B027$*
NOTES:
IDLE MODE SETTING
Idle Mode Off