User`s manual

RS-232
Connector
Scanner
Power
Adaptor
Power
Jack
Scanner
PS/2
Connector
PS/2
Connector
1. Power down the host computer.
2. Disconnect the keyboard cable from the computer.
3. Connect the “Y ” cable between the keyboard and the scanner and computer.
4. Restart the computer.
5. The scanner will beep.
6. Set the scanner to KEYBOARD interface by referring to GROUP 13
(Interfaces)
7. Scanner will beep to confirm the setting.
8. Scan a bar code to confirm that data shows on the monitor.
HOW TO CONNECT THE SCANNER TO THE
HOST TERMINAL: Handheld Barcode Scanner
KEYBOARD WEDGE INTERFACE
RS-232 INTERFACE
1. Power down the host computer.
2. Disconnect the RS-232 cable between the scanner and computer.
3. Connect the power adaptor to the cable.
4. Restart the computer,
5. Plug the power adaptor into a power outlet.
6. The scanner will beep.
7. Set the scanner to RS-232 interface by referring to GROUP 13
(Interfaces).
8. Set RS-232 protocol: Baud Rate, Stop Bits, Handshaking, Data Bits
and Parity.
9. Scan a bar code to confirm that data shows on the monitor.
NOTES:
1. Before plugging the power adaptor into the scanner, be sure the voltage, power
consumption, and inner and outer DC characteristics are correct to avoid serious
damage to the scanner and/or the computer.
2. Make sure the protocol communication settings of the scanner (such as baud rate,
data bits, etc.) match those of the host computer. Otherwise, no data will be
transmitted.
Check the power adaptor to ensure:
1. Input of AC current 110V/ 220V matches the power
supply standard of the country in which the scanner
is being used.
2. Adaptor output is +5V DC
3. The jack input is +5V DC