User`s manual

HOW TO SET PARAMETERS
1. Use the scanner to scan at the bar code representing the function/
parameter you want to set.
2. When you hear two beeps, the new settings have been defined or
updated into the memory processor.
Default parameters are indicated in bold type and underlined
characters. The character font is ARIAL BLACK. CD = Check Digit.
CDV = Check Digit Verification.
Most settings require only a single bar code, but a few need several
different bar codes to be scanned in order to completely define a
setting. They are:
How do you program a scanner with this user’s guide?
Preamble / Postamble (maximum 16 digits)
Step 1: Scan CLR PRE/POSTAMBLE.
Step 2: Scan PREAMBLE or POSTAMBLE.
Step 3: Scan any alphanumeric from Full ASCII Table in Group 53-64
Step 4: Scan PREAMBLE or POSTAMBLE.
Min Length / Max Length
Step 1: Scan MIN LENGTH or MAX LENGTH.
Step 2: Scan two digits from Group 61 or Full ASCII numeric table in Appendix
Step 3: Scan MIN LENGTH or MAX LENGTH.
Accuracy Adjustment
Step 1: Scan ACCURACY ADJUSTMENT.
Step 2: Scan one digit from GROUP 5
Step 3: Scan ACCURACY ADJUSTMENT.
Set Code ID (Example: Code 39)
Step 1: Scan CODE 39 SET ID from Group 8
Step 2: Scan either one or two alphanumerics (maximum 2 digits)
from Full ASCII table in Group 55-61
Step 3: Scan CODE 39 SET ID from Group 8
Set A Data - (CX-Codabar, ABC Codabar, Codabar Coupling).
Step 1: Scan SET INSERT DATA.
Step 2: Scan one alphanumeric character from Full ASCII Table in Group 55-61
Step 3: Scan SET INSERT DATA.
1. The scanner will beep three times as a reminder that a setting is
not yet complete.
2. If you make a mistake, forget a step, etc., scan RESET to start again.
NOTES:
. P023$
*.P023$*