Operating instructions

• Where a DCF signal could not be received (e.g. due to unsuitable installation site), the reception attempt can be

repeated.

For this, press the button "" (19) until the radio mast icon in the lower left of the display disappears. DCF reception

is now switched off. Release the button.

Then press the button "" (19) again until the radio mast icon flashes. Then release the button.

The receiver unit performs another search for the DCF signal as described above.

• The base (24) on the back of the receiver unit can be used to set it up in a suitable position.

For wall installation by a nail or screw, there is a suitable opening (22) on the back of the receiver unit. First remove

the base (24). It can simply be pulled out downwards.

For placing/installation, select a place that is not exposed to direct sunlight (this will cause wrong measured value

for inner temperature/humidity). Also keep sufficient distance to heaters, windows or doors.

For good radio reception, the receiver unit should be as far as possible from electric/electronic devices, metal parts,

cables, etc.

Protect expensive furniture surfaces with suitable pads. Otherwise, they may be scratched.

• Commissioning is now completed.