Operating instructions

Step 4:

Briefly press the "SET" button (2) to go to the next setting.

Step 5:

When "USR" was selected as a city code (see step 3), enter the geographic position as latitude and longitude (you

may enter degrees and minutes). Otherwise, continue with step 6.

Now two dashes flash "- -" for the latitude. Enter the degrees with the "–" (6) or. "+" (7) buttons (keep them pressed

for quick adjustment) and confirm by pressing "SET" (2).

Then two dashes flash "- -" for the minutes. Enter the minutes with the "–" (6) or. "+" (7) buttons (keep them pressed

for quick adjustment) and confirm again by pressing "SET" (2).

Now "N" or "–" flashes. Now use the "–" (6) or "+" (7) buttons to select if these are northern ("N") or southern ("–

") latitudes. Confirm the selections by pressing the "SET" button (2).

Now two dashes flash "- -" for the longitude. Enter the degrees with the "–" (6) or. "+" (7) buttons (keep them pressed

for quick adjustment) and confirm by pressing "SET" (2).

Then two dashes flash "- -" for the minutes. Enter the minutes with the "–" (6) or. "+" (7) buttons (keep them pressed

for quick adjustment) and confirm again by pressing "SET" (2).

Now "W" or "E" flashes. Use the "–" (6) or "+" (7) buttons to select if these are western ("W") or eastern ("E")

longitudes. Confirm the selections by pressing the "SET" button (2).

"0:00 - TZ" now flashes in the display. Adjust the time zone with the "–" (6) or "+" (7) buttons (+15 to -13 hours is

possible): Confirm the selections by pressing the "SET" button (2).

"DST" and "NO" flash in the display. Here you may set if daylight savings time is to be applied, and which one should

be used. For more information on this, see the appendix Confirm the selections by pressing the "SET" button (2).

Step 6:

The year flashes in the display . Set them with the "–" (6) or "+" (7) buttons (as usually, press them longer for quick

adjustment). Confirm the selections by pressing the "SET" button (2).

Step 7:

The month flashes in the display. Set it with the "–" (6) or "+" (7) buttons: Confirm the selections by pressing the

"SET" button (2).

Step 8:

The day flashes in the display. Set it with the "–" (6) or "+" (7) buttons: Confirm the selections by pressing the "SET"

button (2).

Step 9:

"D" and "M" flash in the display. This is where you can set the display order for day and month (day/month = D/M

or month/day = M/D). Select the order using the "." (6) or "+" (7) buttons. Confirm the selections by pressing the

"SET" button (2).

Step 10:

Now the icon "24" (or "12") flashes in the display. Use the "–" (6) or "+" (7) buttons to select if the time is to be

displayed in 24 or 12 hour mode.

In the 12.hour mode, the abbreviation "AM" is displayed for the first and "PM" for the second half of the day next

to the time.

Confirm the selections by pressing the "SET" button (2).