Operating instructions

48
• Briefly push the button “SET” repeatedly until the value you want to set flashes.
• Set the value with the button “+” of “MIN/MAX”. Keep the respective button pressed for quick
adjustment.
• Briefly push the button “ALM” while the value is flashing to switch the alarm on or off.

When the alarm is switched on, the symbol “ ” appears in the corresponding
display area.
This also applies for the wake-up function; the symbol “
” is displayed to the right
of the time.
• Switch to the next setting by briefly pushing the button “SET” and proceed as described
above.
• After setting the last value and pushing the button “SET”, you will leave the setting mode.

Leave the setting mode prematurely by briefly pushing the button “SNOOZE/LIGHT”
or wait for 10 seconds without pushing any button.
Example: Setting the wake-up time, activating/deactivating the wake-up function
• Briefly push the button “ALM” once. “HI AL” appears in the display.
• Briefly push the button “SET”; the hours of the wake-up time flash. Set it with the button “+”
or “MIN/MAX” (for quick adjustment, keep the respective button pushed).
• Briefly push the button “SET”; the minutes of the wake-up time flash. Set it with the button
“+” or “MIN/MAX” (for quick adjustment, keep the respective button pushed).
• While the hours or minutes of the wake-up time flash, the wake-up function can be switched
on (icon “
” appears to the right of the time) or off (icon disappears) by briefly pushing
the button “ALM”.
• There are three ways of leaving the setting mode as described above:
- Push the button “SET” briefly repeatedly until the regular display appears again
- Briefly push the button “SNOOZE/LIGHT”
- Wait for 10 seconds without pushing any button