Operating instructions

f) Startup

• After connecting the mains adapter, a short test of all display segments is started (all segments are displayed).

• An acoustic signal sounds next and the version number of the weather station is displayed.

• Then the indoor temperature and indoor humidity and the barometric pressure are displayed. The corresponding

sensors are installed directly in the display console.



The text „WAIT FOR TRANSMISSION“ appears in the lower part of the display (see Chapter 10 d),

Section 9). The weather station is attempting to contact the outdoor sensors (e.g. after power failure).

During this time the weather station can not be operated. This may take several minutes, please wait.

„MIN MAX RESET CFG“ is then displayed in the lower display section.

• Now you must install the external sensors.

g) Combination sensor

The combination sensor is delivered in parts and must be assembled before startup.

Take the wind vane and the white cylindrical enclosure of the vane, the combination sensor and the poles out of the

packing.

Mount the wind vane as follows:

1. Place the cylindrical enclosure of the wind vane on

the free pole end of the combination sensor sup-

port as shown in the picture.

The bevelled end of the cylindrical enclosure faces

downwards.

2. Guide the connector with the cable through the

base of the wind vane.

Be careful not to damage the connector or twist the

cable.