Operating instructions

80
¨
¨
11. After activating the receive mode with the “ADD” button (“NO. 9 - SYNC” appears in the lower display section
of the console), you have approx. 15 seconds to press the recessed button on the combination sensor once
briefly. This registers the combination sensor at the receiving station and “USED” is displayed instead of
“SYNC”).

It may take several minutes until the combination sensor sends a new packet of measured data to the
display console where they data are displayed. Please wait during this time!
12. Close the housing again by pushing it up and turning it clockwise until
it latches into place.
h) Outdoor / indoor sensors ASH888, S888IA, ASH888I
Please refer to the corresponding manuals for information on how to assemble, address and take these sensors into
operation.