Operating instructions

82
• Touch "SENSOR" repeatedly to select the memory position where to save the desired sensor.

Please bear in mind that the combination sensor can only be saved to memory position 9.
Tips for taking sensors into operation:
To safely take sensors into service, you can activate them first near the weather station. But the distance
between sensor and weather station must not be less than 1 m to avoid interference.
• Select "ADD" and the display will read (example for sensor 9: combination sensor):
SENSOR NO 9 - - SYNC ADD DEL SENSOR NO 9 - - SYNC ADD DEL
SENSOR NO 9 - - SYNC ADD DEL SENSOR NO 9 - - SYNC ADD DEL
SENSOR NO 9 - - SYNC ADD DEL
To synchronise the sensor, press its synchronisation button within the next 15 seconds. The text „USED“ is
displayed instead of „SYNC“; this signals that the sensor has been found and saved successfully.
The data of the combination sensor appear automatically after several minutes in the corresponding display fields
(when receiving a data packet). The data of the remaining sensors will be displayed after selecting the memory
position (“Sensor” field) in the OUTDOOR display segment.
XX
XX
X Identification of occupied memory positions
Memory spaces which are already occupied are highlighted by "USED" after the memory space number.

This information does, however, not indicate whether the corresponding sensor is really active.
This can only be recognized by missing or not up-to-date data during sensor selection and by the active
radio tower signal in the "OUTDOOR" field.
XX
XX
X Deleting a sensor assignment
The serial number of a sensor can also be deleted from the sensor memory if required.
• First proceed as described at “Registration”, select the desired sensor and then apply "DEL" (=delete) instead of
"ADD".
• The "USED" supplement after the sensor number is deleted and the memory space becomes available for
registering a new sensor.