Use and Care Manual

Table Of Contents

Placement

This unit is designed to be free standing and not built-in.

The unit should be placed in a ventilated and dry environment.

Do not put the unit in direct sunlight, and keep it as far as

possible from heat sources.

Don't put the unit in a cold area.

The unit should be placed on ﬂat and stable ground. Keep the

unit level by adjusting the 2 front leg levelers.

There should be 5" (12.7cm) space around the top, sides and back

of the unit as shown, to allow proper ventilation.

Before Use

Before initially plugging in the refrigerator, keep the unit standing upright and stable for

6 hours. The refrigerator should be on for up to 4 hours and adequately cold, before

putting food in it.

It is recommended that you clean the interior of the unit before placing food inside.

5" (12.7cm)

Turn the leveling leg counter-clockwise as far as it will go, until

Slowly turn the leveling leg clockwise until the appliance is level.

the top of the foot is touching the bottom of the chassis.

The appliance ships with the handle inside the cabinet to protect it from damage.

The appliance should be unplugged before installing the handle.

1. Position the handle over the exposed door handle posts.

2. Remove the two screws from the side of door with a screwdriver, insert screws into the

handle bracket and ﬁx it to the side of door and tighten it until ﬁrmly attached.

Handle Installation

5" (12.7cm)