User's Manual

30 kW S-BAND/U ANTENNA GROUP
OPERATION
2.1 Rev. C
CHAPTER 2
OPERATI ON
2 .1 I nt roduct ion
2 .1 .1 Purpose
The present Chapter provides the operating instructions, information and
procedures required to enable operating personnel to efficiently and effectively
operate on the 30 kW S-BAND/U Antenna Group in accomplishing its
designated tasks.
The Chapter is divided in:
Paragraph 2.2 Controls and indicators
Paragraph 2.3 Semi-operative controls
The equipment does not require personnel on steady watch conditions, but
requires general monitoring during normal operating situations. Since the
equipment has no operating controls, paragraph 2.2 is not applicable. All semi-
operative controls are located inside the unit.
2 .2 Cont rols and indica t ors
Since the equipment has no operating controls, this paragraph is not applicable.
2 .3 Sem i- operat ive cont rols
The 30 kW S-BAND/U Antenna Group equipment is fitted with some semi-
operative controls only on the TRANSCEIVER Unit; these controls are
accessible when the unit front cover is opened. The semi-operative control
location is shown in Chapter 9, Figure 9.1.7 and in Figure 9.1.8 and their
description is given in Table 2.3.1 - Semi-operative Controls Location of the the
RTM 30S/U/D Cabinet and in Table 2.3.2 - Semi-operative Controls Location of
the RTM CONT B board.
Table 2.3.1 - Semi-operative Controls Location of the the RTM 30S/U/D Cabinet
POS. CODE TYPE FUNCTION
1 SW2 Interlock TRANSCEIVER cover interlock switch for disabling
the High Voltage generation
Table 2.3.2 - Semi-operative Controls Location of the RTM CONT B board