Technical Manual

SRT X-BAND RADAR SYSTEMS

OPERATION

304202P003 2.10 Rev. C

2.4.4 GENERAL NOTES

1) Rates:

Data transmission rate to TXRX should be:

Sentence CO2 1 Hz normally, or when is necessary

Sentence SE2 when is necessary upgrade Sector Blanking

Sentence TIM every time is necessary timers information or reset values

Sentence DPC every time is necessary digital potentiometer information or value upgrade

Sentence CFG only for first setup

Sentence SPD only for first setup and when the motor controller is changed

Rate shall be not faster than 50ms between two consecutive sentences.

Data transmission rate from TXRX are:

Sentence ST2 1 Hz normally

Sentence DAT connection depending : 1 Hz (Interfaces) or 150ms (TXRX).

Sentences DPI, SE2 on request

Sentences TIM, on request and each 30 minutes of interval after power on.

Sentence NAC when necessary

Sentences HT2 1 Hz normally

Sentences DT3 1 Hz normally

Sentences CFG on request.

Sentences SPD on request

2) Error Code:

MESSAGE ERROR CODE MEANING

CO2

00 CRC ERROR