Technical Manual

SRT X-BAND RADAR SYSTEMS
INSTALLATION
304202P003 8.3 Rev. C
8.1.3 Storage
After the material contained in the boxes has been inspected in the presence of
customer and it has been verified that no damage has occurred, the unit shall
be stored in its original packing until the time of installation. The storage
premises must be dry and well protected.
If the units must be kept in storage for more than one month, it is advisable to
insert hygroscope substances, such as silicon gel salts, in the crates. See par.
8.2 Specification, (Environmental Conditions)
8.1.4 Handling
The antenna and the pedestal must be run up the mast separately and then
assembled.
The pedestal is lifted by crane. Use slings attached to the eyebolts fitted on top
of the pedestal.
Minimum angle at the base is 60º. See Figure 1 (Lifting by crane)
The pedestal contains delicate electronic components - handle accordingly.
The antenna surface is sensitive to impacts and pressure. Any deformation of
the antenna surface can reduce the radar performance. Lift the antenna in
slings, carefully preventing it from slipping.
8.2 Specifications
8.2.1 Dimensions and weights (Also See Out-
line Drawings)
Length
534 mm
Width
364 mm
Height
391 mm
Weight with 6 ft antenna
35 + 5 kg
Weight with 9 ft antenna
35 + 9 kg
Weight with 12 ft antenna
35 + 14 kg
Swing circle with 6 ft antenna
1800 mm
Swing circle with 9 ft antenna
2650 mm
Swing circle with 12 ft antenna
3620 mm