User's Manual

SRT X-BAND RADAR SYSTEMS
ANNEX
304202P003 19 Rev. C
STEP 3 - Apply silicone grease to the hole and slit of the rubber boot. Place the
boot on the waveguide or cable and over the entrance hole. Mark the locations
of the mounting holes.
STEP 4 - Remove the boot and drill the mounting holes 5/16" (8 mm) through
the wall or roof. For concrete, either drill holes through the material or drill larger
holes deep enough to insert bolt anchors.
STEP 5 - Place the boot around the waveguide or cable and over the entrance
hole. Position the flange halves in the groove of the boot and align all of the
mounting holes. Fasten the assembly with 1/4" bolts, flat washers, and nuts
obtained locally. Place the sealing washer supplied under the bolt heads as
shown.
STEP 6 - Wrap the clamp around the boot as shown and tighten it with a
screwdriver to ensure a leak proof seal.