User`s manual

17
5 Installation of Intraskan dc
5.2 Procedure for Input wiring:
• Strip the insulation on each input wire for a length of approximately 5 mm. Using the Paladin Crimping
Tool with Dies 2035 or equivalent, Crimp the three dowel studs to the Line, Neutral and Ground wires
of the Input power cable from wall as shown in Figure 17 .
• Remove the cable clamp (located near the input wiring hole) by removing two (M3x6 HSHC) screws
using 2.5 mm allen key as shown in Figure 18 . Using screw driver fix the line, neutral and earthing
wires coming from the wall to the terminal block such that Line wire matches with label “L”, Neutral wire
matches with label "N" and Earth wire matches Label "E" as shown in Figure 19 .
Figure 17:Dowel stud and Crimping tool
Figure 18: 2 M3x6 hex socket
head cap screws (Use 2.5mm
allen key).
• Fix back the cable clamp routing the input cable
through the clamp with two (M3x6 ) screws using
2.5 mm allen key as shown in Figure 18 .
Figure 19:M3x6 hex socket head cap
screws (Use 2.5mm allen key).