User`s manual

5 Installation of intraskan DC

5.3 Straight- Arm Installation:

• Remove the circlip fixed to the straight-arm guide rod using circlip pliers as shown in Figure 20 .

• Apply grease to the straight arm insertion rod and inner area of the bearing block. Mount the straight-

arm on the base unit bearing block and fix back the circlip to the straight-arm guide rod using circlip

pliers as shown in Figure 21 .

Figure 20

Figure 21

• Check and confirm the level of the straight-

arm using spirit level by rotating to all direc

tions as shown in Figure 22 . If not level, verti-

cal leveling can be done by adding shims be-

tween optional wall plate and base unit plate.

• Horizantal leveling can be done by tilting the

base unit plate.

Figure 22