User`s manual

5 Installation of Intraskan dc

5.6 Ground Connection Check:

Using a Multimeter, check the continuity between the following points:-

• Between Ground point of power board and Tube Head inner Cone metal part,

• Between Ground point of power board and Scissor Arm Guide rod and

• Between Ground point of power board and Base Unit Wall mounting plate as shown in Figure 28 .

• If any of the check fails then check the Ground connections inside Base Unit & Tube Head for Cable fault.

Figure 28: Check the continuity

of ground connection.

5.7 Remote console Installation:

• Take the remote console template from packing box and fix it at the desired location on the stud.

• Confirm the level of the template using spirit level. Mark the locations for the 2 mounting holes on the

template and mark the wiring hole also at the locations shown in Figure 29 .

• Drill the 2 mounting holes marked using 5/32" drill bit to the depth of 1.26" and drill the direct wiring

hole(>1.5" dia).

Figure 29: 2

Mounting holes

Remote Console Template