User`s manual

59
8.13 Replacement of Keypad console:
8.13.1 Removing the Keypad console:
• Execute the steps in “8.2.1.1 Power Off:”.
• Pull out the console assembly from the slot on the Keypad console and remove the front cover by re-
moving 4 M3×6 HSHC Screws using 2.5mm Allen key as shown in Figure 115 .
• Holding the front cover along with console assembly disconnect the console cable from the Console
extension board-external as shown in Figure 116 . Keep the removed parts aside.
• Disconnect the communication cable cable coming from the base unit through the wall from the Con-
sole extension board-external.
• Remove the Console extension board-external PCB from the wall plate by removing 4 M3X6 HSHC
screws using 2.5mm allen key as shown in Figure 117 .
8.13.2 Replacing the Keypad console:
• Take the new keypad console assembly from the packing box and pull out the console assembly from
the slot on the Keypad console and remove the front cover by removing 4 M3×6 HSHC Screws using
2.5mm Allen key as shown in Figure 115 .
• Holding the front cover along with console assembly disconnect the console cable from the Console
extension board-external(If connected) at the location shown in Figure 116 . Keep the removed parts
aside.
• Remove the PCB from the wall plate by removing 4 M3×6 HSHC screws using 2.5mm Allen key as
shown in Figure 117 .
• If required remove the old wall plate by removing 2 M6×30 lag bolts using 8mm box spanner and fix
the new wall plate on the wall with 2 M6×30 lag bolts using 8mm box spanner.
• Take the new PCB and fix it to the wall plate with 4 M3×6 HSHC screws using 2.5mm Allen key as
shown in Figure 117 .
• Connect the communication cable to the appropriate connector by referring the configuration connec-
tion diagrams in Section “5.8 Intraskan DC Console configurations:”.
• Take the new front cover with new console assembly and route the console cable through the hole pro-
vided on the front cover and connect the console cable to the J8 connector on the PCB as shown in
Figure 116 . Fix the front cover with 4 M3×6 HSHC screws using 2.5mm Allen key as shown in Figure
115 .
• Fix the Console assembly in the slot and switch on the unit and give exposures from the external
switch.
• Perform "5.12 Power On Check:" by giving exposures from external console configuration.
Figure 115
Figure 116
Figure 117