User Manual

STEP 3.3: WIRING APPLICATION

Component-to-Component Connections (refer to Fig. F and Fig. G):

1. Route low-voltage connections from component-to-component by using

the included Quick-Snap cover plate.

2. Simply cut the pre-defined knock-out area off the Quick-Snap cover plate

with a utility knife. Refer to Fig. G.

NOTE: The pre-defined knock-out size is 1.25” in diameter.

3. Carefully pull low-voltage wires though the hole in the Quick-Snap cover

plate. Snap back into place and connect wires to the appropriate devices.

4. To run additional low-voltage connections use the remaining positions on

the CON1001 Entertainment Box and repeat steps 1 through 4. For unused

slots, attach the Quick-Snap cover plate.

Figure G

Remove knockout

on back side of

Cover Plate

Plate

Cover