Operation Manual
46
Cleaning and care
m Risk of short circuit!
Do not use high-pressure cleaners or steam jet cleaners to
clean your appliance.
Caution!
Risk of damaging the surface. Do not use sharp or abrasive
cleaning agents. Do not use abrasive cleaning aids such as
steel wool or scourers.
Note: Highly recommended cleaning and care products can be
purchased through our after-sales service. Observe the
manufacturer's instructions.
Cleaning the appliance exterior
Cleaning the cooking compartment
Caution!
Risk of damaging the surface. Do not clean the appliance while
still warm, even if using oven cleaners specially intended for
this purpose.
Notes
■ Due to its technical properties, the enamel can exhibit colour
variations, this however has no effect on the function.
■ The edges of thin trays may be rough. Anti-corrosion
protection is still guaranteed, however.
Keeping the appliance clean
Clean the cooking compartment after each use, as dirt will
bake on the next time it is heated up, and this can only be
removed with difficulty. Always remove flecks of limescale,
grease, starch and albumin (e.g. egg white) immediately.
Where possible use the 3 Hot air operating mode. This
operating mode creates less dirt.
Removing and fitting the appliance door
You can remove the appliance door to clean it more
thoroughly.
m Risk of injury!
The hinges of the appliance door may snap shut with great
force. Always open the hinge locking lever fully when removing
the appliance door and close it fully after refitting. Do not reach
into the hinge.
m Risk of injury!
If the appliance door has only been unhinged on one side, do
not reach into the hinge. The hinge can snap back with great
force. Call the aftersales service.
Removing the appliance door
1. Open the appliance door fully.
2. Open the locking levers on the left and right-hand side fully.
The hinges are secured and cannot snap closed.
3. Close the appliance door until resistance becomes
noticeable (figure A)
4. With both hands, grip the door on the left and right-hand side,
close the door a little more and pull it out (figure B).
Fitting the appliance door
1. Insert the hinges in the left and right-hand holders (figure C).
The notch on both hinges must engage.
2. Open the appliance door fully.
3. Close the locking levers on the left and right-hand side fully
(figure D).
The appliance door is secured and can no longer be
removed.
4. Close the appliance door.
Appliance part/
surface
Cleaning agent/aid
Stainless steel
surfaces
Apply washing-up liquid with a soft,
damp cloth or chamois; dry with a soft
cloth. Use cleaners for matte stainless
steel finishes if very dirty.
Painted surfaces/
glass surfaces
Apply washing-up liquid with a soft,
damp cloth or chamois; dry with a soft
cloth.
Door panels Apply glass cleaner or detergent with a
soft, damp cloth or chamois leather; dry
with a soft cloth.
The inner door panel on the appliance
door has a coating which can have the
effect of a light-coloured film.
Appliance part Cleaning agent/aid
Enamel
surfaces
Apply washing-up liquid or vinegar solution
with a soft, damp cloth or chamois; dry with a
soft cloth. Loosen baked-on food residues
with a damp cloth and detergent. Leave the
cooking compartment open to dry after
cleaning.
We recommend using oven cleaning gel if the
oven is very dirty. This can be applied directly
to the stain.
Door seal Hot soapy water
Hook-in rack Hot soapy water
Accessories Soak in hot soapy water. Clean with a brush
and sponge or wash in the dishwasher.
A B
C
D