Operation Manual

52
Fitting
When fitting, make sure that the lettering "right above" is upside
down at the bottom left on both panels.
1.Insert the lower panel diagonally towards the back (fig. A).
2.Insert the centre panel (fig. B).
3.Stick the retaining clips onto the right and left-hand side of
the panel, aligning them so that the carriers are over the
screw holes, and then screw in place (fig. C).
4.Insert the uppermost panel diagonally towards the back. The
smooth surface must face outwards.
5.Put the cover back in place and screw it on.
6.Attach the oven door.
Do not use the oven again until the panels have been
correctly fitted.
Cleaning the hook-in racks
You can remove the hook-in racks for easier cleaning.
ã=Risk of burning due to hot components in the cooking
compartment!
Wait until the cooking compartment has cooled down.
1.Push the hook-in rack upwards at the front and unhook to the
side (figure A).
2.Pull the hook-in rack forwards at the rear and unhook to the
side (figure B).
3.Clean the hook-in rack with washing-up liquid and a sponge
or brush.
4.Align the hook-in rack with the indentation (a) facing
downwards, so that the shelf heights match.
5.Insert the hook-in rack at the rear as far as it will go and push
to the rear (figure C).
6.Insert the hook-in rack at the front as far as it will go and push
downwards (figure D).
Faults and repairs
In the event of a fault, check the tips in the following table
before calling the after-sales service.
ã=Risk of electric shock!
■ Work on the appliance electronics may only be performed by
a specialist.
■ Always disconnect the appliance from the power supply
when work is carried out on the electronics. Switch off the
circuit breaker or remove the fuse from your household fuse
box.
%
$
&
$ %
D
D
& '
Problem Possible cause Remedial action
Electrical operation is malfunctioning (e.g.
indicator lamps do not light up)
Faulty fuse Check fuses in the fuse box and replace if
necessary
Liquid or thin dough runs to one side Appliance not installed level Check the appliance installation (see the
Installation instructions)
Smoke is generated during roasting or
grilling
Fat is burning on the grill element Continue grilling or roasting until the fat on
the grill element is burnt away
Wire rack or universal pan inserted incor-
rectly
Place the wire rack in the universal pan
and insert them together at a lower shelf
height
High levels of condensation are generated
in the cooking compartment
Normal occurrence (e.g. when baking
cakes with very moist toppings or roasting
a large joint)
Open the appliance door occasionally dur-
ing operation