Operating instructions

Error messages
If an error occurs while a program is running,
the red fields around the buttons flash in
slightly different ways. After taking the
measures described below, turn off the
machine to leave error message mode.
L1
L2
L3L4
L5
L6
The error messages that may be shown are:
The door is not closed
If L1 is flashing, you tried to start a program
with the washer door open. Close the door
and the program will start.
Over flow fault
If all the red fields around the Start/Stop and
Door opening (key symbol) buttons are
flashing, there is too much water in the
machine.
1. Shut off the water tap.
2. Call the service division.
Water outlet fault (Grey Hose)
If L3 is flashing, there is a problem with
drainage. Check:
• that no objects are stuck in the drainage
hose outlet.
• that the drainage pump is not blocked by
foreign objects. Clean the pump (see the
“Care and cleaning” chapter).
• that there are no kinks in the drainage
hose.
Water inlet fault (White Hose)
Fault with water supply. Check:
If L4 is flashing, there is a problem with
drainage. Check:
• that the tap on the water pipe is open.
• that the filter in the machine’s water inlet is
not blocked.
1. Shut off the water tap.
2. Unscrew the hose.
3. Clean the filter in the inlet valve on the
machine.
4. Screw the hose back on.
5. Turn on the tap and check for leaks.
6. Run the program again to check if the fault
is fixed.
7. If this does not resolve the problem, call
the service division.
Door opening fault
If L6 is flashing, call the service division.
18
Troubleshooting