Instructions / Assembly
Spike & Ferrule Insert
ferrule into gutter lined up
with a rafter, hammer spike
through gutter and drip
edge into the fascia.
Hidden Hanger Hook the
hanger under the front lip of
the gutter. Drive a nail or
screw through the hole in
the hanger into the fascia.
Fascia Bracket Align
bracket with the guide
string, nail directly to the
fascia. Place gutter into
bracket and secure with
snap-on cross piece.
Strap Hanger Hook the
hanger under the front lip of
the gutter. Carefully lift
shingles then nail into the
roof deck.
Locate and mark the end of each rafter on the fascia
board (Typically 16 or 24 inches). Use one of the
following methods to hang your gutter. Be sure that
the drip edge hangs into the gutter and not behind it.
Hang Gutters onto the Fascia
3
4
Attach mitres to fascia board
at the corners. Connect
mitres to gutter with slip
connectors. Secure with
screws or pop rivets. Apply
sealant to the inside seams to
protect against leaks.
Connect elbows (a) and
downspout (b) with the
crimped ends pointing down.
Secure the joints with screws
(c). Attach the downspout to
the outlet then attach an
elbow at the bottom to direct rainwater away from the
foundation. Fasten downspout snugly to the wall with
downspout bands. Use 2 downspout bands for each
8-10 foot section of downspout.
SEALANT
HANGERS
a
a
b
b
c
Attach Mitres, Drop Outlets
and Downspouts
Remove old gutters and
inspect fascia board and
metal drip edge, repair or
replace the fascia/drip edge if
needed. Tack a string to the
fascia board 4 or 5 inches below the roofline so that it
is straight, level and taut. Drop one end of the string
1/4 inch per 10 ft., sloping toward downspout.
DOWNSPOUT
DOWNSPOUT
1
Begin assembling your gutter
system on the ground starting
at end furthest from the
downspout. Fit an end cap to the first piece of gutter,
then join gutter sections using slip connectors
secured with screws or pop rivets. Waterproof all
joins with sealant.
Continued on other side...
Assemble Gutter
Sections
2
SEALANT
CONNECTOR
RESIDENTIAL GUTTER
INSTALLATION
Remember…
Pencil
Tape Measure
String
Level
Eye Protection
Screwdriver
Hack Saw
Drill
1 Gutter - 10'
2 Downspout
3 Downspout Strap
4 Hangers
5 Splash Shield
6 Drop Outlet
7 Slip Connector
8 Outside Mitre
9 Inside Mitre
10 Left End Cap
11 Right End Cap
12 End Piece
13 Front Elbow (A)
14 Side Elbow (B)
15 Downspout Extension
# Description
QTY.
Preparation: Measure and mark
with a chalk line
Para Español,
consulte al dorso
1
2
3
4
5
6
7
8 9
10 11
12
13
14
15
Seam Sealer
Touch-Up
Paint