User's Manual

Introduction Getting Ready Taking Pictures Playback Set Up
EN-30
NEXTBACK
Contents Glossary Index Nomenclature Menus and Settings Troubleshooting
Removing the Memory Card
1
Check that the camera is switched off
and then release the card/battery cover
latch.
qUse the pad of your finger to slide the card/battery cover in the
direction of the arrow until there is a click and the latch is released
(approximately 1 mm).
wThe bottom part of the card/battery cover opens (approximately
10 mm).
2 Open the card/battery cover.
ePull out the card/battery cover until it is stopped by the hinge.
rFully open the card/battery cover.
3 Push the memory card in gently with your
fingertip.
When the memory card is pushed in slightly, it pops back out and you
can then remove it.
4 Close the card/battery cover.
Push the card/battery cover into the opening in the camera surface
while you close it, then slide it in the direction of the arrow until it clicks
and locks.
Make sure the hinge does not lift up as you close the cover.
A Important
The card access LED flashes when the camera is storing images in the memory card.
Do not open the card/battery cover or remove the memory card while this light is
flashing. Doing so may corrupt the files on the memory card, or even damage the
camera.
2
1
4
3
Hinge
Push against
the upper
surface.