Instruction manual

Introduction Getting Ready Taking Pictures Playback Set Up
EN-164
Contents Glossary Index Nomenclature Menus and Settings Troubleshooting
[BRIGHT CNTRL] Adjusting the LCD Monitor Brightness
You can adjust the LCD monitor brightness through 5 levels. Set the
brightness to your preferred level.
1 Turn the camera on and press the mode
button D until "G" lights up on the mode
select LED.
2 Move the selector lever up u or down d
to select [BRIGHT CNTRL], then move the
lever right r.
3 Move the selector lever up u or down d
to select the brightness, then press E.
The selected brightness is applied.
[+2] : Sets the maximum brightness.
[+1] : Sets the brightness slightly higher than normal.
[STANDARD] : Normal level of brightness. (Default)
[-1] : Sets the brightness slightly lower than normal.
[-2] : Sets the minimum brightness.
BNote
This setting is retained when you turn the camera off.
AF MODE
FORMAT
BRIGHT CNTRL
DATE
INSERT DATE
SAF
EXECUTE
STANDARD
2004.01.01
NO DATE
POWER SAVE 1MIN.
SET UP(1/3)
+
2
+
1
–
1
–
1
–
2
–
2
AF MODE
FORMAT
BRIGHT CNTRL
DATE
INSERT DATE
STANDARD
POWER SAVE 1MIN.
SET UP(1/3)