User Manual
Table Of Contents
- Copyright
- Trademarks
- Product Configuration
- Introduction
- Overview
- Operating Mode Descriptions
- Setup
- Settings
- Preparing the Utility Software
- Utility Software Settings
- Setting Descriptions
- To Register or Set Up a New Access Point
- To Edit Settings for an Existing Access Point
- To Use Data scramble Functions for Better Security
- To Use SNMP Agent Functions
- To Use Spanning Tree
- To Access the APL from a Different Router
- Spanning Tree Algorithms (STA)
- What is an STA?
- STA Parameters
- Sample STA Application
- _
- All settings other than bridge priority settings are identical.
- The root bridge is determined by the priority settings of each ...
- The designated bridge for each LAN segment is determined by roo...
- The designated port for each bridge is determined by the design...
- The root port of each bridge is determined by its path cost to ...
- Ports that are neither designated ports nor root ports are back...
- _
- SNMP Agent Functions
- Troubleshooting
- Appendix
- Product Specifications
- Input/Output Interface
- Glossary
- _
- IEEE (Institute of Electrical Electronics Engineers)
- IEEE 802.11/ IEEE 802.11b
- MIB (Management Information Base)
- SNMP (Simple Network Management Protocol)
- Diversity
- Router
- Bridge
- LAN (Local Area Network)
- RSSI (Receive Signal Strength Indication)
- Spectrum diffusion transmission
- DS (Direct Sequence)
- CSMA/CA (Carrier Sense Multiple Access with Collision Avoidanc...
- Hidden Terminal Problem
- RTS (Request to Send)
- Roaming
- Peer-To-Peer
- AP (Access Point)
- User Unit
- ESS ID (Extended Service Set ID)
- Channel
- _
- Index
Setup
FX-DS110-APL
17
Using the Magnets (Included)
The magnets included with this product can be used for easy
mounting and removal on steel desks, partitions, or other metal
surfaces.
Notes!
･
Do not place magnets near monitors, floppy disks, or other
sensitive objects.
･
Moving the AP while it is mounted on a steel desk or similar
surface can cause paint scratching.
Attaching and Removing Magnets
To mount the unit using a magnet, push the magnet into the magnet
mounting hole in the direction of arrow 1 as shown in Figure 4.2. ,
then insert the entire magnet into the mounting hole.
Next, slide the magnet in the direction of arrow 2 to hold the unit in
place.
To remove, slide the magnet in the direction of arrow 1 in Figure
4.3. , then lift in the direction of arrow 2.
Magnet
Magnet mounting holes
Figure 4.2. Attaching Magnets Figure 4.3. Removing Magnets