User Manual
Table Of Contents
- Copyright
- Trademarks
- Product Configuration
- Introduction
- Overview
- Operating Mode Descriptions
- Setup
- Settings
- Preparing the Utility Software
- Utility Software Settings
- Setting Descriptions
- To Register or Set Up a New Access Point
- To Edit Settings for an Existing Access Point
- To Use Data scramble Functions for Better Security
- To Use SNMP Agent Functions
- To Use Spanning Tree
- To Access the APL from a Different Router
- Spanning Tree Algorithms (STA)
- What is an STA?
- STA Parameters
- Sample STA Application
- _
- All settings other than bridge priority settings are identical.
- The root bridge is determined by the priority settings of each ...
- The designated bridge for each LAN segment is determined by roo...
- The designated port for each bridge is determined by the design...
- The root port of each bridge is determined by its path cost to ...
- Ports that are neither designated ports nor root ports are back...
- _
- SNMP Agent Functions
- Troubleshooting
- Appendix
- Product Specifications
- Input/Output Interface
- Glossary
- _
- IEEE (Institute of Electrical Electronics Engineers)
- IEEE 802.11/ IEEE 802.11b
- MIB (Management Information Base)
- SNMP (Simple Network Management Protocol)
- Diversity
- Router
- Bridge
- LAN (Local Area Network)
- RSSI (Receive Signal Strength Indication)
- Spectrum diffusion transmission
- DS (Direct Sequence)
- CSMA/CA (Carrier Sense Multiple Access with Collision Avoidanc...
- Hidden Terminal Problem
- RTS (Request to Send)
- Roaming
- Peer-To-Peer
- AP (Access Point)
- User Unit
- ESS ID (Extended Service Set ID)
- Channel
- _
- Index
Settings
FX-DS110-APL
29
Enable DIP Switch
If this box is checked, the DIP switch settings on this unit (mode
and unit type) are enabled.
Factory setting: Checked (DIP switches enabled)
･ Network Mode
Determines the operating mode of this unit. This setting is not
available if 'Enable DIP Switch' is checked.
Factory setting: Setting not available (DIP switch setting enabled).
･ Unit Type
This setting determines whether the unit operates as an access point
or station. In access point (AP) mode, this unit controls other user
units or access points operating in station mode. In station mode,
this unit is controlled by (logged in to) another AP.
Factory setting: Setting not available (DIP switch setting enabled).
Data Scramble
This setting determines whether wireless data is scrambled. Note
that it is not possible to communicate between a terminal with data
scramble enabled and a terminal with data scramble disabled, or
between two terminals with data scramble enabled but using
different scramble keys.
Factory setting: Not checked (data scramble off).
･ Scramble Key
Used for scrambling of wireless data.
Factory setting: [00.00.00.00.00.00.00.00.00.00]
Input values: Hexadecimal values (0-9, A-F).