User Manual
Table Of Contents
- Copyright
- Trademarks
- Product Configuration
- Introduction
- Overview
- Operating Mode Descriptions
- Setup
- Settings
- Preparing the Utility Software
- Utility Software Settings
- Setting Descriptions
- To Register or Set Up a New Access Point
- To Edit Settings for an Existing Access Point
- To Use Data scramble Functions for Better Security
- To Use SNMP Agent Functions
- To Use Spanning Tree
- To Access the APL from a Different Router
- Spanning Tree Algorithms (STA)
- What is an STA?
- STA Parameters
- Sample STA Application
- _
- All settings other than bridge priority settings are identical.
- The root bridge is determined by the priority settings of each ...
- The designated bridge for each LAN segment is determined by roo...
- The designated port for each bridge is determined by the design...
- The root port of each bridge is determined by its path cost to ...
- Ports that are neither designated ports nor root ports are back...
- _
- SNMP Agent Functions
- Troubleshooting
- Appendix
- Product Specifications
- Input/Output Interface
- Glossary
- _
- IEEE (Institute of Electrical Electronics Engineers)
- IEEE 802.11/ IEEE 802.11b
- MIB (Management Information Base)
- SNMP (Simple Network Management Protocol)
- Diversity
- Router
- Bridge
- LAN (Local Area Network)
- RSSI (Receive Signal Strength Indication)
- Spectrum diffusion transmission
- DS (Direct Sequence)
- CSMA/CA (Carrier Sense Multiple Access with Collision Avoidanc...
- Hidden Terminal Problem
- RTS (Request to Send)
- Roaming
- Peer-To-Peer
- AP (Access Point)
- User Unit
- ESS ID (Extended Service Set ID)
- Channel
- _
- Index
FX-DS110-APL
iv
5. Settings
5. Settings5. Settings
5. Settings................................
................................................................
......................................................
.
......................
.
......................
.
......................
.
Preparing the Utility Software ......................................23
Utility Software Settings................................................24
Edit Device Name.......................................................25
Configuration..............................................................26
Firmware.....................................................................27
Status ..........................................................................28
Setting Descriptions .......................................................29
Edit..............................................................................29
Base .............................................................................29
SNMP ..........................................................................32
Spanning Tree.............................................................33
Other Settings.............................................................35
To Register or Set Up a New Access Point.....................36
To Edit Settings for an Existing Access Point ...............36
To Use Data scramble Functions for Better Security ...37
To Use SNMP Agent Functions......................................37
To Use Spanning Tree.....................................................38
To Access the APL from a Different Router...................38
6. Spanning Tree Algorithms (STA)
6. Spanning Tree Algorithms (STA)6. Spanning Tree Algorithms (STA)
6. Spanning Tree Algorithms (STA)................................
................................................................
..................................
....
..
3
33
3
What is an STA?..............................................................39
STA Parameters ..............................................................40
Bridge Level ................................................................40
Port Level....................................................................42
Sample STA Application .................................................43
7. SNMP Agent Functions
7. SNMP Agent Functions7. SNMP Agent Functions
7. SNMP Agent Functions ................................
................................................................
.........................................
.
.........
.
.........
.
.........
.
SNMPc Overview ............................................................47
MIB Support....................................................................48
Control Using SNMPc ....................................................49
Building-in to SNMPc.....................................................50
MIB Database Updates ..................................................50