User Manual
Table Of Contents
- Copyright
- Trademarks
- Product Configuration
- Introduction
- Overview
- Operating Mode Descriptions
- Setup
- Settings
- Preparing the Utility Software
- Utility Software Settings
- Setting Descriptions
- To Register or Set Up a New Access Point
- To Edit Settings for an Existing Access Point
- To Use Data scramble Functions for Better Security
- To Use SNMP Agent Functions
- To Use Spanning Tree
- To Access the APL from a Different Router
- Spanning Tree Algorithms (STA)
- What is an STA?
- STA Parameters
- Sample STA Application
- _
- All settings other than bridge priority settings are identical.
- The root bridge is determined by the priority settings of each ...
- The designated bridge for each LAN segment is determined by roo...
- The designated port for each bridge is determined by the design...
- The root port of each bridge is determined by its path cost to ...
- Ports that are neither designated ports nor root ports are back...
- _
- SNMP Agent Functions
- Troubleshooting
- Appendix
- Product Specifications
- Input/Output Interface
- Glossary
- _
- IEEE (Institute of Electrical Electronics Engineers)
- IEEE 802.11/ IEEE 802.11b
- MIB (Management Information Base)
- SNMP (Simple Network Management Protocol)
- Diversity
- Router
- Bridge
- LAN (Local Area Network)
- RSSI (Receive Signal Strength Indication)
- Spectrum diffusion transmission
- DS (Direct Sequence)
- CSMA/CA (Carrier Sense Multiple Access with Collision Avoidanc...
- Hidden Terminal Problem
- RTS (Request to Send)
- Roaming
- Peer-To-Peer
- AP (Access Point)
- User Unit
- ESS ID (Extended Service Set ID)
- Channel
- _
- Index
Appendix
FX-DS110-APL
54
9. Appendix
Product Specifications
Table 9.1. Physical Specifications
Wired LAN unit Ethernet standard IEEE 802.3
Data transmission speed 10Mbps
Access method CSMA/CD
Wireless LAN unit Transmission format IEEE 802.11b standard DS spectrum diffusion
Data transmission speed 11, 5.5, 2, 1Mbps(fixed/automatic)
Access method CSMA/CA + ACK(RTS/CTS)
Transmission packet IEEE 802.11b frame
Wireless category Low power data transmission system(2400-2497MHz)
Aerial power 10mW/MHz or less
Security Proprietary scramble/WEP(to be available)
Antenna Flat surface diversity antenna
Operating modes Ad hoc, Infrastructure/Station settings available
Dimensions (mm) 81(W) x 26.5(D) x 175(H)
Weight 0.2kg
Specification FX-DS110-APL
Table 9.2. Software Specifications
Protocols
IP(RFC 791), ICMP(RFC 792), UDP(RFC 768),
ARP(RFC 826), SNMP(RFC 1157),
MIB II(RFC 1213)
Specification FX-DS110-APL
Table 9.3. Installation Environment Conditions
(Environment Specifications)
Supply voltage DC 5.5 to 7.0V(using AC adapter)
Current consumption 0.6A(Max.)
Operating temperature 0 to 50°C(main unit) 0 to 40°C(AC adapter)
Operating humidity 0 to 95%(no frost)
Airborne dust Not extreme
Corrosive gases None
Other
Do not obstruct ventilation slits
Leave 5cm open space in all directions
Specification FX-DS110-APL