User Manual

5. Setup and Status Display
FX
-
DS540
-
AP
DL
49
IP address of the master AP
When the master AP exists, specify the IP address of the AP that serves as the master AP.
Factory default setting : 0.0.0.0
IP address of the backup AP
When a backup AP exists, specify its IP address.
Factory default setting : 0.0.0.0
Language setting
Select the language displayed by the terminal or browser from “English” or “Japanese.
Factory default setting : English
Password
Set a password. Enter a string of up to 31 single-byte alphanumeric characters. The password is case
sensitive. At the password input prompt when starting software setup, you can log in by clicking on the
[Setting] button with no password entry.
If you forget your password, initialize the AP using the DIP switch (INIT).
The password is cleared when the AP is initialized. Note, however, that initializing the AP resets all of
its settings to their factory defaults, requiring you to make settings over again. For using the DIP
switches, see Chapter 3.
Factory default setting : (Not input)
Ethernet
Port speed
Select the port speed setting. Select one of “Auto”, “100M Full Duplex”, “100M half Duplex”, “10M
Full Duplex”, or “10M half Duplex”.
Factory default setting : Auto
Link down sense
Enabling “link down sense” stops the wireless capabilities when the wired link of the access point is
disconnected.
Factory default setting : Disable
Wireless LAN
To change the wireless LAN standard (IEEE802.11a/802.11b/802.11g), wireless connection mode, and
unit type, take three steps of “Basic” -> “Details” -> “Security” to make their respective settings.
For any other item, you can change the setting on under “Details” or “Security”.