User's Manual

Warning!

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)

this device may not cause harmful interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the

following two conditions: (1) this device may not cause interference, and (2) this device must accept any

interference, including interference that may cause undesired operation of the device.

Cet appareil est conforme à Industrie Canada exempts de licence standard RSS (s). Le fonctionnement est

soumis aux deux conditions suivantes: (1) ce dispositif ne peut pas provoquer d'interférences et (2) cet

appareil doit accepter toute interférence, y compris les interférences qui peuvent causer un mauvais

fonctionnement de l'appareil.

FCC Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

-Reorient or relocate the receiving antenna. -Increase the separation between the equipment and

receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is

connected. -Consult the dealer or an experienced radio/TV technician for help. To assure continued

compliance, any changes or modifications not expressly approved by the party responsible for compliance

could void the user’s authority to operate this equipment. (Example - use only shielded interface cables when

connecting to computer or peripheral devices).

the device for operation in the band 5150–5250 MHz is only for indoor use to reduce the potential for harmful

interference to co-channel mobile satellite systems;

high-power radars are allocated as primary users of the band 5650-5850 MHz and that these radars could cause

interference and/or damage to LE-LAN devices.

Shielded USB cable must be used to comply with the FCC Class B limit.