User Manual

Opening and closing 61
Controls and equip-
ment
Safety first Vehicle operation Vehicle care Do-it-yourself service Technical data
Emergency locking
If the power locking system fails (power failure), you
will need to lock the passenger door separately.
For this purpose, a mechanical locking device is provided
on the end panel of the passenger door (only visible when
the door is open).
–Open the door.
– Remove the plastic cap using your vehicle key Þ fig. 40.
– Position the key at an angle of 90° to the door trim panel
and push it in the direction shown by the arrow Þ fig. 41.
After you close the door you will not no longer be able to open it
from the outside.
You can open it from the inside, however, by pulling on the door
latch twice.
Anti-theft alarm system
Description
The anti-theft alarm triggers an alarm if anyone
attempts to break into the vehicle.
The anti-theft alarm system triggers an audible alarm and turns on
the emergency flasher if an unauthorized interference with the
vehicle is sensed by the system.
How is the anti-theft alarm system switched on?
The anti-theft alarm system is switched on when you lock the
driver’s door manually using your key, or when you use the remote
control. The system is activated approximately 30 seconds after the
BH0-0039
Fig. 40 Emergency
lock location on the
front passenger's door
BH0-0040
Fig. 41 Emergency
locking of the front
passenger's door
s3p.book Seite 61 Freitag, 5. Juli 2002 12:05 12