User's Manual

ManualsBrandsContinental Automotive Systems ManualsElectronicsModule with Multi-Band LTE and WCDMA

OEM Integration Manual for TVN (FCC ID: LHJ-TVN, IC: 2807E-TVN)

Integration Guide for TVN Module

1. Product Overview

TVN 4G/3G module is a proprietary modem designed and manufactured by Continental

Automotive Systems, Inc. The modem will be integrated into a telematics control unit (TCU),

designed and developed by Continental Automotive, Inc. The TCU will be installed into

consumer vehicles during the vehicle OEM’s factory assembly process. Primary use-cases are

data-centric with data and voice connections to Telematics Service Providers (TSP).

Figure 1. Top view of TVN module. Figure 2. Bottom view of TVN module.

TVN Feature Table:

Feature Description

Operating Bands LTE FDD: 13, 4, 2, and 5

WCDMA: II and V

Application Interface USB

4 wire UART

2 wire UART

Audio: PCM ACC_POWER_ON pin

Hardware Reset Pin

BOOT_OK status pin

MSG indicator pin

JTAG Antenna interface (Primary, MIMO)

Data Services LTE: data rates 100MBps DL / 50Mbps UL

Summary of content (5 pages)

PAGE 1
OEM Integration Manual for TVN (FCC ID: LHJ-TVN, IC: 2807E-TVN) Integration Guide for TVN Module 1. Product Overview TVN 4G/3G module is a proprietary modem designed and manufactured by Continental Automotive Systems, Inc. The modem will be integrated into a telematics control unit (TCU), designed and developed by Continental Automotive, Inc. The TCU will be installed into consumer vehicles during the vehicle OEM’s factory assembly process.
PAGE 2
OEM Integration Manual for TVN (FCC ID: LHJ-TVN, IC: 2807E-TVN) 2. Regulatory Compliance Note FCC: This device complies with Part 2, Part 22(H), Part 24(E) and Part 27 of the FCC Rules. The FCC ID for this device is LHJ-TVN. Operation is subject to the following two conditions: 1. This device may not cause harmful interference. 2. This device must accept any interference received, including interference that may cause undesired operation.
PAGE 3
OEM Integration Manual for TVN (FCC ID: LHJ-TVN, IC: 2807E-TVN) Typical RF trace layout between the TVN module and RF Connector: Recommended RF Connector Type: Fakra X203 is the recommended connector location for MIMO1 (primary antenna) connector. Recommended RF trace length is less than 40 mm. X202 is the recommended connector location for MIMO2 (diversity antenna) connector. Recommended RF trace length is less than 45 mm.
PAGE 4
OEM Integration Manual for TVN (FCC ID: LHJ-TVN, IC: 2807E-TVN) PCB Material: FR 4 PCB design information: Microstrip on layer 1 with ground on layer 2 / 50 ohm Single Ended Line/ 840 µm W 840 µm S Stripline on layer 2 with ground on layers 1&3 / 50 Ohm Single Ended Line/ 405 µm W iv. v. vi. vii. viii. ix. Automotive OEM is responsible for ensuring that the end-user has no manual instructions to remove or install module. The module is limited to installation in mobile applications, according to Part 2.
PAGE 5
OEM Integration Manual for TVN (FCC ID: LHJ-TVN, IC: 2807E-TVN) Antenna requirements for use with TVN module: • The module must be installed to provide a separation distance of at least 20cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. The TVN module is for use with external antennas ONLY. For all operating bands the maximum antenna gain is 6 dBi including cable loss.