_ ov STOP...DON'T TAKE ME BACK TO THE STORE. LOOK...FOR THE TOLL-FREE “HELP” TELEPHONE NUMBER. LISTEN...AS THE EXPIRES TALK YOU THROUGH THE PROBLEM. For intermediate answers to your questions regarding operation, wising parts or installation, wall the SOUTHWESTERN BELL FREEDOM PHONE® RETAIL SALES HELP LINE AT: 1-800-366-0037 8:30am. 4350p. EST SOUTHWESTERN BELL FREEDOM PHONE® 7475 N.
PLEASE READ IMPORTANT SAFETY INSTRUCTIONS BEFORE USE. Congratulations! You have purchased a 40-Channel Cordless Telephone with Dual Keypad Speakerphone halt has been manufactured to the highest standards of SOUTHWESTERN BELL FREEDOM PHONES Retail Sales.
IMPORTANT SAFETY INSTRUCTIONS Cont) Safety Instructions for Batteries Handset Battery Pack CAUTION Use only « Southwestern Bell Brenton Phove® approved battery pack in the handset of your FF Cordless Telephone. To reduce the isk of five or injury, always do the following when replacing, discarding or charging batteries. When handling the batteries, be careful not to short the battery with conducting materials such as rings.
_ Le Handset Diagram Base Diagram HANDSET CONTROLS: The diagram below shows the controls BASE CONTROLS: This diagram shows the controls of the F020 Base. of the FREE handset.
Traits of Cordless Telephones A. Cordless telephones offer convenience and mobility during telephone conversations. The we of cordless telephones is dependent pan the availability of AC power. Any disruption of electrical power at your location would prevent the placing or receiving of telephone calls. IU is recommended that a cordless telephone should not be installed as the only phone at your location.
Installation (Cont) NOTE: BATTERY BACK MUST BE CHAR POR 10-14 HOURS BEFORE INITIAL OPERATION. Wall Mounting: The FF) may be mounted on a wall phone plate or ante 2 screws (104 chuffed) that you fasten to the wall For either type of installations, complete the following steps first 1. Insert the AC adapter into the back of the unit Tread the adapter cord through the groove iu the back of the unit. The cord will exit [rom the bottom.
Operation IMPORTANT NOTICE: “Tone / Pulse Operation The FIO will operate on tone oF rotary (pulse) systems. 1 If your hones is wired far rotary service, move the Simultaneous (TP) switch lo the Pulse position (P) 21 your house iy wired for Tone rice, move the ‘TP switch to the Tone position (T) 3.1 you arc unsure of the type of dining service you have, set the switch to Tone (T). On the handset, press the TALK bunion and then any digit on the keypad. If the dial tone sits, switch fo Rube (P).
Operation (Cont'd) Using Speakerphone To make or answer a call without using the handset, press the SPEAKER It ton on the base. You will be connected ta the line, The SPEAKER LED wilt light. To disconnect, press SPEAKER bunion again.
Operation (Cont) Dialing will follow the programmed Tone/Pulse setting, even when using Temporary Tone. To Change a Stored Number: Replace a sired number by program wing a new number in its place Your will ear a beep confirming the new number has been stored. Redial Sour FRX) remembers the East banshee dated. This is a convenient feature when trying to place a call through to a phone number that is not being answered or in continuously busy. 1.
Operation (Cont) To joins a call already in progress on the base, press the TALK button an the handset (ONLY IF THE HANDSET 1S ALREADY OUT OF THE BASE) The appropriate LED will light Call ‘Fraser Transferring a call from the base to the handset The call should already be in progress through the base, and the SPEAKER LED will be lit IF THE HANDSET IS IN THE BASE CRADLE : 1. Pick up the handset, and begin speaking rough the handset. IF THE HANDSET IS CLOSE TO THE BASE CRADLE (LE.
FCC Wants You To Know This equipment complies with Part 68 of the FOC rules. On the bottom of the apse of fis equipment is a label tat contains, an tong other information, the FCC Registration Number and Ringer Equivalence Number (REN) for this equipment You must, upon request, provide this information to your telephone company ‘The REN is useful to determine the quantity of devices you may connect to your telephone line and still have all of those devices vying when your tel. phone masher is enrolled.
— Troubleshooting Guide Cont) PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION The handset only quarks close To the The base antenna is nol fully upright. Fully aright The base centenarian for the best results. The incoming signal is intermittent or fades. The battery is uot charged. Recharge the battery The handset is being wed too far away from the base. Move the handset closer 10 the base, The bse antenna is not fully upright, Fully upright the base antenna.
| Service According to 1900 regulations, tis equipment, which has been registered by the FCC, may only be repaired by authorized person adjustments ave made by an unauthorized person, the FOC eo voided. Should you encounter any problems, please Freedom Phone® toll-free Customer Help Line for Monday ~ Friday between the hours of 830 am-430 pm (E website at HTTP wivwswblreedomphone.conm.