Owners Manual
17
OPERATIONS MANUAL
BOTTLE, KEG & BACK BAR COOLERS, GLASS & PLATE CHILLERS
the large hole in the plate lines up with the threaded hole under
the compressor compartment. Screw the threaded end of a leg
or caster through the hole in the plate and into the threaded
hole under the compressor compartment. Fasten the other end
of the plate to the threaded hole under the storage compart-
ment cabinet with a bolt and washer (supplied with the original
cabinet crating). Screw another leg or caster into the threaded
hole under the storage compartment, at the opposite end of the
cabinet. Tilt the cabinet in the opposite direction and install the
remaining support plate and legs or casters.
INSTALLING LEGS OR CASTERS
If your new unit is supplied with optional legs or swivel casters,
they will be packed in the accessory box that came with your
cabinet. Legs or casters should only be installed only when the
cabinet is close to its final location.
IMPORTANT: Make sure your legs or casters are tight-
ened extremely well after installation, otherwise the
cabinet will be unstable and may sway or rock, which can
damage your unit.
KC & BBC MODELS
To install legs or casters, place wooden blocks along the back,
at each end. Tilt the cabinet back, using the wood blocks to help
hold the cabinet in its tilted position. Locate the large threaded
holes in the bottom of the cabinet and simply screw the threaded
studs on your legs or casters into the threaded holes. Repeat
this procedure by tilting the cabinet in the opposite direction and
installing the remaining legs or casters.
CBC MODELS
Follow the steps below for your cabinet. Models purchased with
optional legs or casters are provided with:
CBC24 & CBC64 (4) Legs or Casters
CBC37 & CBC50 (4) Legs or Casters, plus
(2) Support Plates (shipped loose)
CBC95 (6) Legs or Casters
CBC24 & CBC64 MODELS
Install your (4) legs or casters under the refrigerated storage
compartment of your cabinet by placing wooden blocks along
the back, at each end. Tilt the cabinet back, using the wood
blocks to help hold the cabinet in its tilted position. Locate the
proper threaded holes along the bottom front of your cabinet
(see Figure 12). Screw the threaded studs on your legs or cast-
ers into the holes as shown. Repeat this procedure by tilting the
cabinet in the opposite direction and installing the remaining
legs or casters.
CBC95 MODEL
Follow the steps above to install (6) legs or casters under the
storage compartment, as shown (see Figure 12).
CBC37 & CBC50 MODELS
For maximum stability, (2) support plates are provided and
must be attached from under the storage compartment to the
bottom of the compressor compartment (see Figure 13). To
install legs or casters on these models, place wooden blocks
along the back, at each end. Tilt the cabinet back so the blocks
help support the cabinet. Position one support plate as shown so
FIGURE 13: Installation of Legs or Casters - CBC37 & CBC50
FIGURE 12: Installation of Legs or Casters -
CBC24, CBC64 & CBC95